THE DEVELOPMENT OF LOW COST ELECTRONIC STETHOSCOPE

Today is the day. Today is 25 April 2013 is the big day for all Final Year Projects student because today we had been to present our pr...

After being check by our supervisor, this is our final poster for our project. We will need to use this poster for our presentation in we...

Our project has finished. This is the final look of our product w hi ch is t he electronic stethoscope. It is working perfectly. N ow al...

Putting circuit into case We have drill suitable holes in the case to put in the switch, audio jack, potential meter, wire for ste...

The PCB Circuit board We use this hand drill to drill holes in the PCB board Soldering components This week we drill h...

    This is the PCB circuit for our project. We design the PCB circuit using ExpressPCB software.  We print the PCB cir cuit...

These are the results that i get after testing my circuit in the oscilloscope. We compare the waveform with the theory heart sound and...

  I have bought most of the components at Jalan Pasar and above is the picture of the circuit i have construct on the breadboard for tes...

  As instructed by my supervisor, this is the new circuit diagram that he asked me and my partner to do. We will try this circuit first a...

I have captured the output sound and waveform of heartbeat from the circuit as instructed by my supervisor, Sir Mohd Zubir Suboh. I ...

These are the components that i bought from Nixie Electronics in Jalan Pasar, KL. I bought 2 set of these components and it just c...

This is the circuit that I will use to build my project. There are other circuit that can be use to build my p...

This blog will be my official blog for my Final Year Project. For my FYP, I want to make an electronic stethoscope. My FYP will be supervi...